Scyld ClusterWare HPC: Administrator's Guide | ||
---|---|---|
<< Previous | Disk Partitioning | Next >> |
This section addresses the default partitioning schemes used by Scyld ClusterWare.
The default Scyld partition table allocates 4 partitions:
/boot partition
/home partition
/ partition
Swap partition = 2 times physical memory
The default partition table allocates three partitions for each compute node:
BeoBoot partition = 2 MB
Swap partition = half the compute node's physical memory or half the disk, whichever is smaller
Single root partition = remainder of disk
For diskless operation, the default method of configuring the compute nodes at boot time is to run off a RAM disk. This "diskless" configuration is appropriate for many applications, but not all. Typical usage requires configuration and partitioning of the compute node hard disks, which is covered in the partitioning scenarios discussed in the following section.
<< Previous | Home | Next >> |
Disk Partitioning with ClusterWare | Up | Partitioning Scenarios |